Dyson V11 Torque Drive — User Manual

Installation Requirements

• The Dyson V11 Torque Drive must be installed on a level,
  stable surface capable of supporting its full operating weight.
• Ensure adequate ventilation clearance as specified
  in the installation diagram on page 4.
• Connect to a correctly rated power supply — refer to the data plate for
  voltage and amperage requirements.
• Plumbing connections (where applicable) must comply with local building
  regulations and be completed by a qualified professional.

First Use

• Before first use, run
  the Dyson V11 Torque Drive through an empty cycle to clean the drum and internal components.
• Remove all packaging
  materials, transit bolts, and protective films before operating.
• Set the clock and any regional settings via the
  control panel as described in Chapter 2.
• Register your appliance on the Dyson website to activate the full
  manufacturer warranty.

Operating Programs

• The Dyson V11 Torque Drive offers a range of
  programmes designed for different load types and energy efficiency levels.
• Eco mode reduces energy and water
  consumption by up to 40% compared to standard cycles.
• Quick wash cycles are suitable for lightly soiled loads and
  complete in under 30 minutes.
• Refer to the programme guide in Section 3 for a full list of settings, temperatures,
  and spin speeds.

Cleaning & Maintenance

• Clean the door seal and detergent drawer of your
  Dyson V11 Torque Drive monthly to prevent mould and odour build-up.
• Run a maintenance wash at 60 degrees Celsius
  with a drum cleaning tablet every 3 months.
• The filter should be checked and cleaned after every 10 cycles to
  maintain drainage performance.
• Descale the appliance every 3 months in hard water areas using a Dyson-approved
  descaling agent.

Error Codes & Troubleshooting

• Error codes on the Dyson V11 Torque Drive
  display indicate specific faults — consult the error code table in Appendix A.
• E1/F1 errors typically relate to
  water supply issues — check the inlet hose and water pressure.
• If the appliance does not start, verify the door
  is fully closed and the child lock is not activated.
• For persistent faults not resolved by the troubleshooting
  guide, contact Dyson customer service with your model and serial number.