Electrolux ESM48310SX — User Manual

Installation Requirements

The Electrolux ESM48310SX must be installed on a level,
stable surface capable of supporting its full operating weight.
Ensure adequate ventilation clearance as specified
in the installation diagram on page 4.
Connect to a correctly rated power supply — refer to the data plate for
voltage and amperage requirements.
Plumbing connections (where applicable) must comply with local building
regulations and be completed by a qualified professional.

Before first use, run
the Electrolux ESM48310SX through an empty cycle to clean the drum and internal components.
Remove all packaging
materials, transit bolts, and protective films before operating.
Set the clock and any regional settings via the
control panel as described in Chapter 2.
Register your appliance on the Electrolux website to activate the full
manufacturer warranty.

The Electrolux ESM48310SX offers a range of
programmes designed for different load types and energy efficiency levels.
Eco mode reduces energy and water
consumption by up to 40% compared to standard cycles.
Quick wash cycles are suitable for lightly soiled loads and
complete in under 30 minutes.
Refer to the programme guide in Section 3 for a full list of settings, temperatures,
and spin speeds.

Clean the door seal and detergent drawer of your
Electrolux ESM48310SX monthly to prevent mould and odour build-up.
Run a maintenance wash at 60 degrees Celsius
with a drum cleaning tablet every 3 months.
The filter should be checked and cleaned after every 10 cycles to
maintain drainage performance.
Descale the appliance every 3 months in hard water areas using a
Electrolux-approved descaling agent.

Error codes on the
Electrolux ESM48310SX display indicate specific faults — consult the error code table in Appendix A.
E1/F1 errors
typically relate to water supply issues — check the inlet hose and water pressure.
If the appliance does not
start, verify the door is fully closed and the child lock is not activated.
For persistent faults not resolved by
the troubleshooting guide, contact Electrolux customer service with your model and serial number.