Dyson Ball Animal 3 Extra — User Manual

Installation Requirements

• The Dyson Ball Animal 3 Extra must be installed on a
  level, stable surface capable of supporting its full operating weight.
• Ensure adequate ventilation clearance as
  specified in the installation diagram on page 4.
• Connect to a correctly rated power supply — refer to the data
  plate for voltage and amperage requirements.
• Plumbing connections (where applicable) must comply with local
  building regulations and be completed by a qualified professional.

First Use

• Before first
  use, run the Dyson Ball Animal 3 Extra through an empty cycle to clean the drum and internal components.
• Remove
  all packaging materials, transit bolts, and protective films before operating.
• Set the clock and any regional
  settings via the control panel as described in Chapter 2.
• Register your appliance on the Dyson website to activate
  the full manufacturer warranty.

Operating Programs

• The Dyson Ball Animal 3 Extra offers a
  range of programmes designed for different load types and energy efficiency levels.
• Eco mode reduces energy and
  water consumption by up to 40% compared to standard cycles.
• Quick wash cycles are suitable for lightly soiled
  loads and complete in under 30 minutes.
• Refer to the programme guide in Section 3 for a full list of settings,
  temperatures, and spin speeds.

Cleaning & Maintenance

• Clean the door seal and detergent
  drawer of your Dyson Ball Animal 3 Extra monthly to prevent mould and odour build-up.
• Run a maintenance wash at 60
  degrees Celsius with a drum cleaning tablet every 3 months.
• The filter should be checked and cleaned after every
  10 cycles to maintain drainage performance.
• Descale the appliance every 3 months in hard water areas using a
  Dyson-approved descaling agent.

Error Codes & Troubleshooting

• Error codes on the Dyson Ball
  Animal 3 Extra display indicate specific faults — consult the error code table in Appendix A.
• E1/F1 errors
  typically relate to water supply issues — check the inlet hose and water pressure.
• If the appliance does not
  start, verify the door is fully closed and the child lock is not activated.
• For persistent faults not resolved by
  the troubleshooting guide, contact Dyson customer service with your model and serial number.