Dyson Digital Slim Fluffy SV18 — User Manual

Installation Requirements

The Dyson Digital Slim Fluffy SV18 must be installed on
a level, stable surface capable of supporting its full operating weight.
Ensure adequate ventilation clearance as
specified in the installation diagram on page 4.
Connect to a correctly rated power supply — refer to the data
plate for voltage and amperage requirements.
Plumbing connections (where applicable) must comply with local
building regulations and be completed by a qualified professional.

Before first
use, run the Dyson Digital Slim Fluffy SV18 through an empty cycle to clean the drum and internal
components.
Remove all packaging materials, transit bolts, and protective films before operating.
Set
the clock and any regional settings via the control panel as described in Chapter 2.
Register your appliance on
the Dyson website to activate the full manufacturer warranty.

The Dyson
Digital Slim Fluffy SV18 offers a range of programmes designed for different load types and energy efficiency
levels.
Eco mode reduces energy and water consumption by up to 40% compared to standard cycles.
Quick
wash cycles are suitable for lightly soiled loads and complete in under 30 minutes.
Refer to the programme guide
in Section 3 for a full list of settings, temperatures, and spin speeds.

Clean the door seal and detergent drawer of your Dyson Digital Slim Fluffy SV18 monthly to
prevent mould and odour build-up.
Run a maintenance wash at 60 degrees Celsius with a drum cleaning tablet every 3
months.
The filter should be checked and cleaned after every 10 cycles to maintain drainage
performance.
Descale the appliance every 3 months in hard water areas using a Dyson-approved descaling
agent.

Error codes on the Dyson Digital Slim Fluffy SV18
display indicate specific faults — consult the error code table in Appendix A.
E1/F1 errors typically relate to
water supply issues — check the inlet hose and water pressure.
If the appliance does not start, verify the door
is fully closed and the child lock is not activated.
For persistent faults not resolved by the troubleshooting
guide, contact Dyson customer service with your model and serial number.