Dyson Purifier Hot+Cool HP09 — User Manual

Installation Requirements

The Dyson Purifier Hot+Cool HP09 must be installed on a
level, stable surface capable of supporting its full operating weight.
Ensure adequate ventilation clearance as
specified in the installation diagram on page 4.
Connect to a correctly rated power supply — refer to the data
plate for voltage and amperage requirements.
Plumbing connections (where applicable) must comply with local
building regulations and be completed by a qualified professional.

Before first
use, run the Dyson Purifier Hot+Cool HP09 through an empty cycle to clean the drum and internal components.
Remove
all packaging materials, transit bolts, and protective films before operating.
Set the clock and any regional
settings via the control panel as described in Chapter 2.
Register your appliance on the Dyson website to activate
the full manufacturer warranty.

The Dyson Purifier Hot+Cool HP09 offers
a range of programmes designed for different load types and energy efficiency levels.
Eco mode reduces energy and
water consumption by up to 40% compared to standard cycles.
Quick wash cycles are suitable for lightly soiled
loads and complete in under 30 minutes.
Refer to the programme guide in Section 3 for a full list of settings,
temperatures, and spin speeds.

Clean the door seal and detergent
drawer of your Dyson Purifier Hot+Cool HP09 monthly to prevent mould and odour build-up.
Run a maintenance wash at
60 degrees Celsius with a drum cleaning tablet every 3 months.
The filter should be checked and cleaned after
every 10 cycles to maintain drainage performance.
Descale the appliance every 3 months in hard water areas using a
Dyson-approved descaling agent.

Error codes on the Dyson
Purifier Hot+Cool HP09 display indicate specific faults — consult the error code table in Appendix A.
E1/F1
errors typically relate to water supply issues — check the inlet hose and water pressure.
If the appliance does
not start, verify the door is fully closed and the child lock is not activated.
For persistent faults not resolved
by the troubleshooting guide, contact Dyson customer service with your model and serial number.