Miele TDA150C — User Manual

Installation Requirements

• The Miele TDA150C must be installed on a level, stable
  surface capable of supporting its full operating weight.
• Ensure adequate ventilation clearance as specified in the
  installation diagram on page 4.
• Connect to a correctly rated power supply — refer to the data plate for voltage
  and amperage requirements.
• Plumbing connections (where applicable) must comply with local building regulations and
  be completed by a qualified professional.

First Use

• Before first use, run the Miele TDA150C
  through an empty cycle to clean the drum and internal components.
• Remove all packaging materials, transit bolts,
  and protective films before operating.
• Set the clock and any regional settings via the control panel as described
  in Chapter 2.
• Register your appliance on the Miele website to activate the full manufacturer
  warranty.

Operating Programs

• The Miele TDA150C offers a range of programmes designed for
  different load types and energy efficiency levels.
• Eco mode reduces energy and water consumption by up to 40%
  compared to standard cycles.
• Quick wash cycles are suitable for lightly soiled loads and complete in under 30
  minutes.
• Refer to the programme guide in Section 3 for a full list of settings, temperatures, and spin
  speeds.

Cleaning & Maintenance

• Clean the door seal and detergent drawer of your Miele
  TDA150C monthly to prevent mould and odour build-up.
• Run a maintenance wash at 60 degrees Celsius with a drum
  cleaning tablet every 3 months.
• The filter should be checked and cleaned after every 10 cycles to maintain
  drainage performance.
• Descale the appliance every 3 months in hard water areas using a Miele-approved descaling
  agent.

Error Codes & Troubleshooting

• Error codes on the Miele TDA150C display indicate
  specific faults — consult the error code table in Appendix A.
• E1/F1 errors typically relate to water supply
  issues — check the inlet hose and water pressure.
• If the appliance does not start, verify the door is fully
  closed and the child lock is not activated.
• For persistent faults not resolved by the troubleshooting guide,
  contact Miele customer service with your model and serial number.